White ABS for the Skull. Brown HIPS for the base.

.18 mm layer height

20% infill

Total print time about 20 hours.

Model found on Thingiverse: http://www.thingiverse.com/thing:308335

Model created by Byambaa

Model from Thingiverse

HIPS Filament

.18 mm Layer Height

20% infill

Printed in two pieces - body sitting upright and head printed from neck up. No supports on either - did use a raft for the head though.

Print time approximately 9 hours combined

Model Created by Justin Butschi

Printed in ABS

Print time about 30 hours

.18 mm layer height

Supports were used.

Model created by Justin Butschi

ABS Filament

.18 mm Layer Height

20% infill

Printed in position as shown with supports.

Print time approximately 11 Hours